NEWS INFORMATION
要求垂直度好，切縫表面光潔，無條紋。
切口寬度與光束模式和聚焦后的光斑直徑有很大的關系，根據光束模式和焦距，二氧化碳激光束聚焦后的光斑直徑一般為0.12-0.3mm。
熱影響區盡可能小，沒有材料燃燒，沒有熔化層形成，沒有較多的熔渣，沒有脆性斷裂。
切口表面粗糙度。 他是衡量激光切割表面質量的關鍵。厚度小的工件比厚度大的工件容易得到較高等級的粗糙度。切割金屬的同一切口表面上，中，下部分的粗糙度并不相同，靠近激光束上端表面的粗糙度最小，越往下端的粗糙度越大。對較薄工件而言，如厚度小于3mm，激光切割表面的上，中，下部分的粗糙度差別很小。激光切割表面質量等級一般以下端粗糙度為標準。這樣較切合實際，也易于掌握。
![l2-1FF41AH2_340_240[1].jpg](/upfiles/2019/1554697720728915.jpg "1554697720728915.jpg")
Require a good degree of vertical, cut surface smooth, no stripes.
2 slit width
The width of the incision has a great relationship with the beam mode and the diameter of the focused spot. According to the beam mode and focal length, the diameter of the light spot after the focus of the carbon dioxide laser beam is generally 0.12-0 .3 mm.
3 Thermal impact area width
The thermal impact area is as small as possible, no material combustion, no melting layer formation, no more slag, no brittle fracture.
Surface roughness of the incision. He is the key to measuring the quality of laser cutting surfaces. The workpiece with a small thickness is easier to obtain a higher degree of roughness than the workpiece with a large thickness. The roughness of the cut metal on the surface of the same mouth, middle and lower parts is not the same, and the roughness near the surface of the upper end of the laser beam is minimal, and the roughness of the lower end is greater. For thinner workpieces, if the thickness is less than 3mm, the roughness of the upper, middle, and lower parts of the laser cutting surface is very small. The quality grade of laser cutting surface is generally the standard for the bottom roughness. This is more practical and easy to master.